search
Search

Enter keywords to search for products.

English
Production bases

Production bases

Production Lines

The Anhui base covers 26,000 m², with 18,000 m² of workshop buildings and close to 200 sets of production equipment. Fluoroplastic molding, component casting, machining and assembly run in separate workshops, producing over 32,000 pump and valve units per year across 10 series.
Production Lines
Production Lines
Production Lines
Production Lines
Production Lines
Production Lines
Production Lines
Production Lines
Production Lines

Quality Control and Testing

Pumps are hydrostatically tested at 1.6 MPa design pressure, then run on test benches to verify flow, head and efficiency against rated parameters at 2900 or 1450 rpm. Incoming fluoroplastic resin is batch-inspected before molding. The quality system is ISO9001 certified, and test reports ship with each order.
Quality Control and Testing
Quality Control and Testing

Fluoroplastic Molding Workshop

Fluoroplastic Molding Workshop

Fluoroplastic Alloy and F46 resin are molded or inserted onto the pressure-bearing metal shells of pump bodies, covers and impellers. Sintering temperature and cooling rate are controlled per batch, which determines the lining's resistance to cracking under thermal cycling.


Casting and Machining

Casting and Machining

HT200 pump casings, covers and metal inserts are cast and machined on site. Keeping casting in the same production system as lining shortens lead times and allows dimensional tolerances to be matched between the metal shell and the fluoroplastic layer.


Assembly and Test Bench

Assembly and Test Bench

Assembled pumps are coupled to motors and run on test rigs before packing. Magnetic drive units are additionally checked for coupling torque and dry-run protection response, covering the failure modes most common in field operation.

message